S&S Cycle MR103 Easy Start Cam Kit For Harley Twin Cam 2006-2017

S&S Cycle MR103 Easy Start Cam Kit For Harley Twin Cam

If you’ve put together a hot bike – or if reliability is paramount – an S&S Easy Start Cam Kit should be on your list. Don’t bother fooling with compression releases or massive-output batteries and super-high-buck starters. S&S designed the Easy Start cams with performance in mind, but then revamped the design to give you great power on a cam that starts easier than a dirtbike. At the center of the cam lives a centrifugally retracted, spring loaded compression release lobe milled into the heel of each exhaust lobe. At cranking speeds, the lobe bumps the exhaust valve open slightly during the compression stroke, making the engine much easier to turn over. Once the engine fires and reaches 800 RPM, the lobe swings out of the tappet roller path, allowing the engine to run normally and with full compression. Ain’t technology great?

Features:

• Start any engine regardless of displacement or compression ratio with a stock starter
• Save your starter and battery; tested for 10,000 starts without running battery down
• Allows for easy start by initially reducing cranking compression, but once the engine starts and rpm increases, the compression release lobe is centrifugally retracted and the engine runs normally, with full compression, and without any loss in performance
• Available in chain drive and gear drive versions
• All chain-drive cams include installation kit
• All gear-drive cams include 4-gear set and installation kit
• Made in the USA

MR103 Cam Info:

• Bolt-in cam for 103″ Twin Cam engines
• Broad torque curve improves output over the entire RPM range
• Intake open/close 13°/33°
• Exhaust open/close 50°/22°
• Intake duration 226°
• Exhaust duration 252°
• Lift .585″